Download  Print this page

To Change The Position For The Steeringcable Pivot Bolt; To Change The Handlebar Stopper Posi-Tion - Yamaha SUPERJET 700 2003 Owner's/Operator's Manual

Hide thumbs

Advertisement

Table of Contents
To change the position for the steering
cable pivot bolt:
1. Pull back the outer sleeve, and then dis-
connect the steering cable.
2. Remove the steering cable joint from the
steering cable pivot bolt.
3. Loosen the pivot bolt and install it with
the lock washer in the desired position
(P1 or P2). Make sure to tighten it to the
specified torque.
Tightening torque:
5.4 N·m (0.5 kgf·m, 3.9 ft·lb)
4. Install the steering cable joint on the
steering cable pivot bolt.
To change the handlebar stopper posi-
tion:
1. Loosen the handle stopper nut 2 on the
operator's side of the steering pole.
2. Lift and turn the handlebar stopper to the
desired position (S1 or S2), and then
tighten the handlebar stopper nut. Make
sure to tighten it to the specified torque.
Tightening torque:
31 N·m (3.1 kgf·m, 22.4 ft·lb)
3. Install the steering pole cover securely.
4-22
E

Advertisement

Table of Contents
loading

This manual is also suitable for:

2003 superjet 700