3. Attach the clip 1 to the engine shut-off
switch 2. Also, attach the engine
shut-off cord 3 to your left wrist.
Check that the engine shut-off cord is not
frayed or broken, and keep it free from
the handlebars so the engine stops if the
operator falls off. The engine shut-off
cord may not pull free if wrapped around
the handlebars when the operator falls
off, allowing the watercraft to continue to
run and cause an accident.
It is not possible to start the engine with the
clip removed from the engine shut-off
4. Pull and hold the choke knob all the way
out to start a cold engine.
The choke should not be used when the
engine is warm.
5. While lightly squeezing the throttle lever,
push the start switch (green button).
On this watercraft, the engine is con-
nected directly to the jet pump. Starting
the engine immediately generates some
thrust. Apply only enough throttle to
keep the engine running.