Table of Contents
Advertisement
Hardware Preparation and Installation
Installation Instructions
2
The following sections discuss installation of the MVME167 into a VME chassis, and
system considerations. Ensure that EPROM devices are installed as needed. Factory
configuration is with two EPROMs installed for the MVME167Bug debug monitor, in
sockets XU1 and XU2. Ensure that all header jumpers are configured as desired.
MVME167 Module Installation
Now that the MVME167 module is ready for installation, proceed as follows:
1.
Turn all equipment power OFF and disconnect power cable from ac power source.
C
aution
!
WARNING
2.
Remove chassis cover as instructed in the equipment user's manual.
3.
Remove the filler panel(s) from the appropriate card slot(s) at the front and rear of
the chassis (if the chassis has a rear card cage). The MVME167 module requires
power from both P1 and P2. It may be installed in any double-height unused card
slot, if it is not configured as system controller. If the MVME167 is configured as
system controller, it must be installed in the leftmost card slot (slot 1) to correctly
initiate the bus-grant daisy-chain and to have proper operation of the
IACK-daisy-chain driver. The MVME167 is to be installed in the front of the
chassis and the MVME712X is to be installed in the front or the rear of the chassis.
Other modules in the system may have to be moved to allow space for the
MVME712M which has a double-wide front panel.
4.
Carefully slide the MVME167 module into the card slot. Be sure the module is
seated properly into the P1 and P2 connectors on the backplane. Do not damage
or bend connector pins. Fasten the module in the chassis with screws provided,
making good contact with the transverse mounting rails to minimize RFI
emissions.
5.
Remove IACK and BG jumpers from the header on the chassis backplane for the
card slot the MVME167 is installed in.
2-6
Inserting or removing modules while power is applied could
result in damage to module components.
DANGEROUS VOLTAGES, CAPABLE OF CAUSING
DEATH, ARE PRESENT IN THIS EQUIPMENT. USE
EXTREME CAUTION WHEN HANDLING, TESTING, AND
ADJUSTING.
WARNING
MVME167 Single Board Computer User's Manual
Advertisement
Table of Contents
