Replacing The Fuses - Yamaha VIRAGO XV250V Owner's Manual

1. Battery
2. Battery breather hose
To store the battery
1. If the motorcycle will not be used
for more than one month, remove
the battery, fully charge it, and then
place it in a cool, dry place.
2. If the battery will be stored for more
than two months, check the specif-
ic gravity of the electrolyte at least
once a month and fully charge the
battery whenever necessary.
3. Fully charge the battery before in-
stallation.
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals and
PERIODIC MAINTENANCE AND MINOR REPAIR
that the breather hose is properly
routed, in good condition, and not
obstructed.
CAUTION:
If the breather hose is positioned in
such a way that the frame is ex-
posed to electrolyte or gas expelled
from the battery, the frame could
suffer structural and external dam-
ages.
6-31

Replacing the fuses

ECA10600
1. Main fuse
2. Signaling system fuse
The main fuse and the signaling sys-
tem fuse holders are located under the
rider seat. (See page 3-8.)
If a fuse is blown, replace it as follows.
1. Turn the key to "OFF" and turn off
the electrical circuit in question.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
Specified fuses:
Main fuse:
20.0 A
Signaling system fuse:
10.0 A
EAU23600
6