Sidestand; Sidestand/Clutch Switch Operation Check - Yamaha Diversion XJ600N Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS

Sidestand

This model is equipped with an ignition
circuit cut-off system. The motorcycle
must not be ridden when the sidestand
is down. The sidestand is located on
the left side of the frame. (Refer to
page 5-1 for an explanation of this sys-
tem.)
This motorcycle must not be operat-
ed with the sidestand in the down
position. If the stand is not properly
retracted, it could contact the
ground and distract the operator, re-
sulting in a possible loss of control.
Yamaha has designed into this mo-
torcycle a lockout system to assist
the operator in fulfilling the respon-
sibility of retracting the sidestand.
Please check carefully the operating
instructions listed below and if there
is any indication of a malfunction,
return the motorcycle to a Yamaha
dealer immediately for repair.
EAU00330
Sidestand/clutch switch
operation check
Check the operation of the sidestand
switch and clutch switch against the in-
formation below.
Be sure to use the centerstand
l
EW000044
during this inspection.
If improper operation is noted,
l
consult a Yamaha dealer.
TURN MAIN SWITCH TO ÒONÓ AND
ENGINE STOP SWITCH TO Ò
TRANSMISSION IS IN GEAR AND
SIDESTAND IS UP.
PULL IN CLUTCH LEVER AND
PUSH START SWITCH.
EAU00332
ENGINE WILL START.
CLUTCH SWITCH IS OK.
EW000046
SIDESTAND IS DOWN.
ENGINE WILL STALL.
SIDESTAND SWITCH IS OK.
Ó.
3-17