Operation And Important Riding Points - Yamaha V-Star XVS1100AWR Owner's Manual

Hide thumbs Also See for V-Star XVS1100AWR:
Table of Contents

Advertisement

1. Turn the fuel cock lever to "ON".
2. Turn the key to "ON" and make
sure that the engine stop switch is
set to "
".
3. Shift the transmission into the neu-
tral position.
NOTE:
_
When the transmission is in the neutral
position, the neutral indicator light
should be on, otherwise have a
Yamaha dealer check the electrical cir-
cuit.
_

OPERATION AND IMPORTANT RIDING POINTS

4. Turn the starter (choke) on and
completely close the throttle. (See
page 3-9 for starter (choke) opera-
tion.)
5. Start the engine by pushing the
start switch.
NOTE:
_
If the engine fails to start, release the
start switch, wait a few seconds, and
then try again. Each starting attempt
should be as short as possible to pre-
serve the battery. Do not crank the en-
gine more than 10 seconds on any one
attempt.
_
5-2
CAUTION:
_
G
The oil level warning light
should come on when the key is
turned to "ON", and then go off
after two to three seconds. If the
oil level warning light flickers or
remains on after starting, imme-
diately stop the engine, and
then check the engine oil level
and the vehicle for oil leakage. If
necessary, add engine oil, and
then check the warning light
again. If the warning light does
not come on when turning the
key to "ON", or if it does not go
off after starting the engine with
sufficient engine oil, have a
Yamaha dealer check the elec-
trical circuit.
G
The engine trouble warning
light should also come on when
the key is turned to "ON". If the
warning light does not come on
when the key is turned to "ON",
flashes or remains on after
starting the engine, have a
Yamaha dealer check the elec-
trical circuit.
_
ECA00103
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xvs1100atcXvs1100awcV-star xvs1100atr

Table of Contents