Operating Sequence - Westinghouse SI 910 SA Care And Use Manual

Table of Contents

Advertisement

Operating sequence

1.
Check the filters
Ensure they are clean and properly
positioned (see cleaning instructions).
2.
Check that there is rinse aid
and salt
3.
Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
4.
Ensure that the spray arms can
rotate freely.
5.
Measure out detergent
Add the required amount of detergent into
the dispenser according to the "Washing
programmes" chart.
6.
Close the detergent dispenser
lid
7.
Close the dishwasher door
8.
Set the programme
Turn the programme selector dial clockwise
until the number of the programme you
wish to select corresponds with the
programme marker.
If necessary select the temperature of the
main wash according to the instructions in
the "Washing programmes" chart (see
"Required pushbuttons").
9.
Start the programme
Depress the power button.
The power indicator light will come on
and the machine will start.
If you wish to interrupt the wash
programme at any time press the button
again.
10. At the end of the washing
programme
At the end of the washing programme the
machine stops automatically.
The power indicator light remains on
until the power button is depressed.
11. Switch off the dishwasher
Switch off the dishwasher by pressing the
power button and open the door.
Wait a few minutes before removing the
dishes, in this way they will be cooler and
the drying will be improved.
When the wash programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
In general it is not advisable to open the
door while the machine is working;if the
door is opened however, a safety device
ensures that the machine stops.
Caution
Do not open the door during the hot
phase: this may cause hot water
escape.
Care must be taken if the door is
opened during the hot phase or
immediately after a programme has
finished, as steam may escape.
15
POS24GB

Advertisement

Table of Contents
loading

Table of Contents