Replacing The Oven Light - Zanussi ZOB 889 Instruction Booklet

Models in stainless steel or aluminium:
We recommend to clean the oven door using only a wet
sponge and dry it up after cleaning with a soft cloth.
Never use steel wool, acids or abrasive products as they
can damage the oven surface. Clean the oven control
panel following the same precautions.
Oven Shelves
Supports
To clean the oven shelves, soak in warm soapy water and
remove stubborn marks with a
impregnated pad.
Rinse well and dry with a soft cloth.
The shelf supports can be removed for easy cleaning.
Proceed as follows:
1) remove the front screw while keeping the shelf support
in position with the other hand (Fig. 12);
2) disengage the rear hook and take off the shelf support
(Fig. 13);
1) once the cleaning is carried out, refit the shelf supports
following the procedure in reverse.
Please, ensure the retaining nuts are secure when
refitting the shelf support.
When cleaning the shelf supports, take care
not to remove the lubricating grease behind
the telescopic runners. This is meant to ensure
their good operation.

Replacing the Oven Light

Ensure the electricity supply is switched off
before carrying out this operation.
The oven bulb has to comply to these features:
a) resistant to temperatures of 300 °C;
b) electric rate: 230 V - 50 Hz;
c) electric power rate: 25 W;
d) connection type: E 14.
To replace the bulb, proceed as follows (Fig. 14):
a) push in and turn the glass lid anticlockwise;
b) remove tha faulty bulb;
c) replace it with a new one;
d) refit the glass lid;
e) switch on the electricity supply.
14
and Shelf
well wetted soap
Fig. 12
Fig. 13
Fig. 14