Transmission Reservation - Sharp AL-2060 Operation Manual

TRANSMISSION RESERVATION

When your fax is busy receiving an original or transmitting an original from memory, you can "reserve" a
transmission by setting the original (either in the RSPF or on the document glass), reading it into memory, and
entering the fax number. Once the current operation is completed, your fax will automatically dial the number and
transmit the original saving you from having to wait.
When Using the RSPF:
1
Confirm that there are no originals on
the document glass and that copying
is not in progress, then gently close
the RSPF.
2
Adjust the original guides to the width
of your original.
3
Place the original face up and push it
gently into the RSPF. The top edge of
the original should enter the fax first.
Original face up
4
Enter the number of the receiving
machine using one of the following
methods:
• Press a Rapid key.
If you press a Rapid Key, the next step is not
necessary.
The number will be dialed once the current
operation is completed, and transmission will
begin once the connection is made.
• Press the [SPEED/SEARCH] key and enter a
Speed Dial number.
• Enter a full number with the numeric keys.
5
Press the [START] key (
entered a Speed Dial number or a full
number.
• The number will be dialed once the current
operation is completed, and transmission will
begin once the connection is made.
68
Adjust the resolution
and/or contrast settings if
desired.
) if you
When placing the Original on the Table:
1
Confirm that there are no original(s) in
the RSPF, and open the RSPF.
2
Place the original face down on the
document glass. Align the original
according to the original scale in the
illustration below. (Line up the center
of the edge of the original with the
( ) mark.)
Original
scale
mark
3
Gently close the RSPF.
When using the document glass, do not set
Note
original(s) in the RSPF.
4
If needed, set the original size,
resolution, and contrast. (See
"DIALING AND TRANSMITTING" (p.57))
5
Press the [START] key (
the page into memory. If you have
more than one original to read into
memory, place the next page, and
press the [START] key (
each page.
6
Press the # key (
) to scan
) to read
).