Gas Connection - Siemens HM 442200 N Instruction Manual

Gas connection

For the authorised
personnel or service
employee authorised
by the manufacturer
If the oven seals are excessively dirty, then the oven
door may not close fully while the oven is in use. The
surfaces of the furniture nearby will be damage over
time. Keep the oven seal clean.
Installation must be carried out only by authorised
personnel or a service employee authorised by the
manufacturer and in accordance with the "Gas
connection and conversion guidelines".
The setting requirements for this appliance are noted
on the identification plate located on the back of the
appliance. The default gas type is marked with a star
(*).
Before installing the appliance, make sure that the
local gas requirements (gas type and pressure) are
suitable for the appliance settings. If the appliance
settings need to be changed, consult the "Gas
connection and conversion guidelines".
This appliance is not connected to a device that
evacuates combusting products. This appliance must
be connected and commissioned in accordance with
the relevant rules and regulations for installation. Do
not connect the appliance to an exhaust gas outlet.
Particular attention should be paid to the rules
regarding ventilation.
Gas connection should be made with a rigid, non
flexible connection (gas pipe) or an approved safety
gas hose.
If an approved safety hose is used then care must be
taken to ensure that it is not squashed or crushed in
any way. The hose must not come into contact with
hot surfaces.
The gas may be connected (gas pipe or safety gas
hose) to the left or the right side of the appliance. The
connection must have an easily accessible shut off
device.
9