Toshiba B-SA4TP SERIES Owner's Manual page 52

2. PRINTER SETUP
2.7.6 Real Time Clock Setting
(Cont.)
NOTE:
1. Be sure to load the battery and set
the low battery check function to
ON whenever the real time clock
is used. If the battery is not
loaded or the battery voltage is
low, the real time clock data is
erased at the power off time.
2. When the low battery check
function is set to ON and if the
battery voltage is 1.9V or less, the
printer will result in a "LOW
BATTERY" error and stop at the
power on time. As a restart is
invalidated in this case, hold
down the [RESTART] key to
cause the printer to enter
<1>RESET mode, access the Real
Time Clock setting mode, and set
the low battery function to OFF.
(3) Low Battery Check Setting
This parameter is to choose whether to activate the low battery check
function or not.
<8>RTC SET
LOW BATT. CHECK
Press the [PAUSE] key to set.
[RESTART]
[FEED]
After selecting the low battery check, press the [PAUSE] key.
(4) RTC Data Renewal Timing Setting
This parameter is to choose the RTC data renewal timing.
<8>RTC SET
RENEWAL
Press the [PAUSE] key to set.
[RESTART]
[FEED]
After selecting the RTC data renewal timing, press the [PAUSE] key.
The current date is displayed.
<8>RTC SET
DATE 06/03/01
Press the [FEED] and [RESTART] keys at the same time to return to the
<8>RTC SET display.
<8>RTC SET
E2-38
ENGLISH VERSION EO1-33048
2.7 Setting an Operating Environment
LOW BATT. ON
LOW BATT. OFF
RENEWAL BATCH
Batch print is possible. However, the same time is
printed on the all media issued in a batch because
the real time clock data is read only for the first
media.
RENEWAL PAGE
A real time can be printed on each media. However,
the printer needs to stop the motion before printing
each media to read the real time clock data.
Low battery check is
activated.
Low battery check is not
activated.