Supply Specifications; Media; Media Type - Toshiba B-SA4TP SERIES Owner's Manual

7. SUPPLY SPECIFICATIONS

7. SUPPLY SPECIFICATIONS

7.1 Media

Please make sure that the media being used is approved by TOSHIBA TEC. The warranty does not apply when a
problem is caused by using media that is not approved by TOSHIBA TEC.
For information regarding TOSHIBA TEC approved media, please contact a TOSHIBA TEC authorised service
representative.

7.1.1 Media Type

Two types of media can be loaded for this thermal transfer and direct thermal printer: label or tag. The table
below shows size and shape of the media available for this printer.
Stop
position
Cut position
Item
Media pitch
Label length
Media width/backing paper width
Label width
Gap length
Black mark length (Tag paper)
Maximum effective print width
Effective print length
Print speed up/slow down area
Thickness
Maximum outer roll diameter
Roll direction
Inner core diameter
Black Mark
(on reverse side)
Label
Label dispensing mode
Thermal direct
Thermal transfer
Thermal direct
Thermal transfer
Thermal direct
Thermal transfer
Thermal direct
Thermal transfer
Thermal direct
Label
Thermal transfer
Thermal direct
Tag paper
Thermal transfer
Thermal direct
Thermal transfer
Stop
position
Cut position
Feed Direction
Batch mode
10.0 – 999.0
19.0 – 999.0
15.0 – 999.0
8.0 – 997.0
17.0 – 997.0
13.0 – 997.0
25.0 – 118.0
25.0 – 114.0
22.0 – 115.0
22.0 – 111.0
2.0 – 20.0
104.0 (200-dpi type), 105.7 (300-dpi type)
6.0 – 995.0
15.0 – 995.0
11.0 – 995.0
8.0 – 997.0
13.0 – 997.0
0.08 – 0.17 (Note 4)
0.1 – 0.17 (Note 4)
Inside/Outside
Ø38, 40, 42, 76.2±0.3
E7- 1
ENGLISH VERSION EO1-33048
Black Mark
(on reverse side)
Tag paper
Strip mode Cut mode
19.0 - 999.0
16.0 – 997.0
2.0 – 5.0 3.0 – 20.0
2.0 – 10.0
14.0 - 995.0
-----
17.0 – 997.0
1.0
0.13 – 0.17 0.08 – 0.17 (Note 4)
0.13 – 0.17 0.1 – 0.17 (Note 4)
Ø152.4
7.1 Media
[Unit: mm]