Automatic Switch Off; Child Safety - Zanussi ZSM 705 K Operating And Installation Manual

Table of Contents

Advertisement

AUTOMATIC SWITCH OFF

Should you forget to switch the oven off after a
programme, or if the "ON" button is pressed
accidentally, the oven will switch off
automatically.
In fact, in the case of manual functioning, the
programmer will switch the oven off automatically
if no other button is activated after a certain time.
This time varies according to the temperature
setting of the oven, and ranges from a minimum of
2 hours for temperatures above 230 C, up to 8
hours for those below 120 C.
At the end of automatic cooking, the oven will
switch off after a period of time, this depends on
the temperature selected.
The time varies between 2 hours for temperatures
above 230 C, up 8 hours for those below 120 C.

CHILD SAFETY

To avoid children altering a selected programme
or temeperature, the Child Safety facility can be
operated.
Press buttons 1 and 3 simultaneously for
approximately 5 seconds.
The padlock symbol
It is now only possible to select any programme
while simultaneously pressing button 1 "Child
safety".
To cancel the Child Safety Feature, press button 3
"ON". Then press button 1 and 2 simultaneously
for approximately 5 second and the padlock
symbol will disappear from the display.
Minute minder
Press button 7 and then buttons 9 or 10 to set the
desired time. This function can be used without
having to switch the oven on (ie: for boiling an
egg on a hob).
Call for technical assistance
The programmer display carries out a self check,
in order to verify that it is working correctly. If a
problem is identified the spanner symbol will be
displayed in the event of a breakdown a NUMBER
will appear. If NUMBERS 001 or 002 appear it
means that the meat probe is at fault and needs to
be replaced; if a higher number appears, please
contact your nearest Zanussi Service Force Centre
quoting the number of Fault Code.
14
will be displayed.
NOTE:
Generally after about 8 seconds from pressing a
function button the programmer will allow the
selected function to operate. Should another button
be pressed during the operation of a function the
display will show momentarily details of the
function in progress. For the new command to be
accepted it will be necessary to press the other
button again.
CHILD SAFETY
1
2
3
4
5
6
7
10
8
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zsm 705 w

Table of Contents