Table of Contents
Advertisement
Using the programmes
ELECTRONIC PROGRAMMER
All the oven functions are controlled by an electronic programmer, this programmer permits you to select
a particular type or combination of heating elements, cooking temperature and automatic timing.
The function selected will be displayed on the programme display panel as shown on page 10.
Different ways of using each programme are detailed under the individual cooking functions.
SETTING THE TIME OF DAY
The oven has 24hr clock.
When the oven is connected to the electrical supply,
the display will automatically show 12:00.
To set the clock, press buttons 5 and 6 at the same
time, release them and enter the required time by
pressing either button 10 to increase the time or
button 9 to decrease the time.
NOTE: The clock will automatically revert back to
12:00 if the time is not selected within 3 seconds.
In the event of a power failure, the clock will revert
to 12:00 and will require resetting.
ON/OFF SWITCH
The oven must be switched on before a programme
can be selected. When the 'ON' button (button 3) is
pressed, the fan oven symbol and oven light will
illuminate. The cooling fan will automatically start.
To switch the oven 'OFF', press button 2, the oven
light will go out and the display will show the time of
the day.
SELECTING A PROGRAMME
When selecting a cooking programme, the procedure
is the same whether you select fan oven cooking,
grilling or any other function. Bread proving has a
pre-set temperature, which cannot be altered.
Each programme is detailed separately but detailed
below is the procedure for the complete range of
symbols and oven functions. Each symbol and oven
function will be explained in further detail on the
relevant pages in the instruction book.
If at any time you wish to cancel a programme,
switch the oven OFF by pressing button 2 "OFF" and
reselect.
1. Switch the oven "ON" by pressing button 3. The
interior light will illuminate and the oven fan will
come into operation.
2. Press the function selector (button 8) until the
required programme is displayed on the control
panel.
3. Select the required temperature by pressing button
9 to decrease, or 10 to increase the
temperature.
The selected temperature will be displayed on the
control panel. After a few seconds, the temperature
will indicate the current temperature of the oven.
12
CLOCK-SETTING THE TIME OF DAY
1
2
3
4
5
6
7
2
3
Oven On
Oven Off
SELECTING A PROGRAMME
1
2
3
4
5
6
7
PM
Advertisement
Table of Contents
