Troubleshooting - Thrustmaster FERRARI WIRELESS GT COCKPIT 430 scuderia Edition User Manual

TROUBLESHOOTING

The wheel is not perfectly centred in the games:
- Switch off the wheel (by setting the switch to OFF). Physically centre the wheel. Next, switch the wheel
back on (by setting the switch to ON).
- If the problem persists, you can manually centre the wheel. To do this, position the wheel in perfect
alignment with the centre, and then simultaneously press "SELECT + START + ENGINE START" (this
operation must be carried out each time the wheel is switched on).
- On the PC, if the wheel or pedals are not properly calibrated, download the "Thrustmaster Calibration
Tool v 1.03" manual calibration software available at the following address: http://ts.thrustmaster.com.
My wheel or pedals do not work correctly:
- Switch the wheel off and back on again (making sure the wheel is centred on start-up).
- Check the condition of the 4 LR6 / AA batteries and that their polarities are correctly positioned.
- If the problem persists, switch off your computer or your console, disconnect the USB receiver as well as
the power cord, reconnect all of them again, then restart and launch your game again.
On PC, my wheel is detected but does not work with my game:
Open the interface for managing your game's "Options" to configure your wheel. Refer to your game's
user manual or online help for more information.
On PS3, my wheel is not detected:
- In "1 player" mode: If your official gamepad is turned on, you will have to switch it to "controller port 2" (using
the "PS" button) for your wheel to be functional.
- If the problem persists, switch off your gamepad while leaving only the wheel connected.
My pedals do not work correctly in "Separate Mode":
(E.g. when the game is running, the selection cursor moves all by itself)
Exit the game and switch the pedals to "combined" mode. Then return to your game to reconfigure the
wheel in your game's option management interface.
My wheel cannot connect itself to the receiver:
The connection between the wheel and the receiver is made automatically.
In the event of a connection failure, you can force the connection by pressing the LED button of the
receiver (16), then simultaneously on your wheel's SELECT + START +
The LED flashes continuously:
You must change the batteries.
SAFETY RECOMMENDATIONS AND INFORMATION
During extended periods of non-use, switch off the wheel (by setting the switch to OFF),
remove the wheel from its base and remove the 4 batteries from the battery compartment.
18/20
buttons.