Download  Print this page

Replacing Carbon Brushes; Metal Cutting; Maintenance - Makita 4300BA Instruction Manual

Hide thumbs

Advertisement

Finishing edges
005936
To trim edges or make dimensional adjustments, run the
blade lightly along the cut edges.
For smoother cutting of plywood or other workpiece with
easily splintered surfaces, transparent tape may be used
over your cutting line.

Metal cutting

005937
Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause significant blade wear.
The underside of the workpiece can be greased instead
of using a coolant.
1
005938

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
1. Cutting oil
1
1. Grease

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
005939
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
These
accessories
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Jig saw blades
Hex wrench 3
Rip fence (Guide rule)
Circular guide
Dust cover set
8
1. Limit mark
1
1. Screwdriver
2. Brush holder
cap
1
2
or
attachments
Only use
accessory or
are

Hide quick links:

Advertisement

loading

  Also See for Makita 4300BA

This manual is also suitable for:

4300bv