Husqvarna Z48 Operator And Parts Manual page 10

8
FRONT WEIGHTS
(See Figure 8)
CAUTION
DO NOT operate mower with grass catcher,
unless the front weights are installed.
1. Remove foot rest from the front of the mower.
2. Remove the two (2) front bolts that secure
the caster casting to the sides of the frame.
3. Remove the two (2) bolts that secure the
caster castin to the bottom of the frame.
4. Place weight bracket on the front of the
frame.
FOOT REST
PREVIOULY REMOVED
HARDWARE
539113177 (CAST WEIGHT)
10
ASSEMBLY
539113225
(WEIGHT BRACKET)
539990588
(BOLT, 3/8-16 X 2, GR5)
FIGURE 8
5. Secure the weight bracket to the frame with
the four (4) previously removed bolts.
6. Install weight to the weight bracket with two
(2) bolts (539990588) and two (2) nuts
(539976979).
7. Install foot rest on the weight bracket with six
(6) (539113183 and two (2) (539113182)
screws.
NOTE: the shorter screws go in the center.
539113182
(SCREW #10-12 X 1)
539976979
(NUT, 3/8-16, NYLOC)
539113183
(SCREW #10-12 X 1 1/4)