Helpful Hints - One for All SPORT User Manual & Code Book

Trouble-Shooting

Helpful Hints

Problem: Solution:
Red light does not Replace batteries with 4 fresh, new
blink when you press AAA alkaline batteries.
a key?
The ONE FOR ALL Make sure you are using new
does not respond batteries and are aiming the ONE
after pressing a key? FOR ALL at your device.
The ONE FOR ALL A) Try all the codes listed for your
does not operate your brand.
device(s)? B) Try the search method on page
14.
Your brand is not Try the search method on page 14.
listed in the ONE FOR
ALL code section?
When following the Did you use the Code Lock feature?
set-up instructions, You must first unlock the code
the red light on the before entering a new code. Follow
ONE FOR ALL only the instructions on page 13 to do
blinks once instead of this.
twice after you enter
a three-digit code?
The ONE FOR ALL is You may be using the wrong code.
not preforming Start the search method over again
commands properly? to locate the proper code.
Press a key but get Hold SET until the red light blinks
the wrong result? twice, then press 992 and the
device key twice. You will need to
set-up your device again. Try the
codes for your brand or the search
method on page 14.
You cannot control Hold SET until red light blinks
the volume feature of twice. Then press 993 and VOL+. To
your Satellite, Cable set the volume control back to TV
Converter or TV/ (Punch Through), hold Set until the
Video combination or red light blinks twice, then press
you cannot control 993 TV.
the volume of your
TV set up on the AUX
key?
Problems changing Enter the programme number
channels? exactly as you would on your
original remote.
Video not recording? As a safety feature on your ONE
FOR ALL, you must press the Record
key twice.
Scan does not work Make sure your original remote had
on your device? a programme +/- key.
16