Learning the Commands of
your components
By using the Learning function, it is possible for this
commander to perform learned operations.
Setting remote control codes that are not
stored in the commander
When a remote control code is not one of the presets
stored in the commander, it is possible for the commander
to learn the code using the Learning function.
1
Press SET UP and move the easy scroll key to select
“LEARNING”, then press the key to enter the
selection.
The function list appears.
<LEARNING>
[VIDEO 1 ]
[VIDEO 2 ]
[VIDEO 3 ]
2
Move the easy scroll key to select the function you
want to use the Learning function, then press the
key to enter the selection.
The button list appears.
Button[VIDEO 2 ]
*POWER
REVERSE
*PLAY
3
Move the easy scroll key to select the button you
want to use for the Learning function, then press
the key to enter the selection.
The learning display appears.
[VIDEO 2 ]
Function
(REVERSE)
Button
LEARNING Start
CLEAR
4
Point the remote code receiver section of the
commander toward the receiver/transmitter on the
remote control to be learned.
About 5 cm ~ 15 cm
5
Move the easy scroll key to select “Learning Start”,
then press the key to enter the selection.
“Learning Now!!” is displayed.
Page 18