Table of Contents
Advertisement
VCR Display Information
All the information you need on the VCR status will be summarised on the on-screen display. If you are record-
ing, playing back a tape or watching a broadcast on the video channel, you can call up three standard on-
screen displays. The display can be selected by pressing ON SCREEN on the Remote, 1, 2, 3 or 4 times.
Programme number and channel
Tape Status
NICAM signal
Audio output mode
Tape speed
Tape remaining
Time
Date
Tape counter
• If the clock is not set, the time and date will not be displayed.
• When tape playback mode,"channel"is not displayed
Each time ON SCREEN on the Remote is pressed, the display on the TV screen changes the mode in the
following sequence:
AUTO mode → FULL mode → Counter mode → OFF mode
• AUTO mode .................... The current mode and channel number will be displayed for 3 seconds when
• FULL mode .................... All the active features will also be shown on screen.
• Counter mode ................ This display will show the tape counter and amount of tape remaining.
• OFF mode ...................... This will remove the display from the screen.
Each time DISPLAY on the Remote is pressed, the VCR Front Panel Display changes the mode in the following
sequence:
Clock mode → Channel position mode* 1 → Tape counter mode → Tape remain mode
• Clock mode..................... The current time will be displayed.
• Channel position mode..The channel position will be displayed.
• Tape counter mode.........The current tape position will be displayed.
• Tape remain mode.......... The amount of video tape remaining will be displayed.
• The default time and date will not be displayed if the clock has not been set.
• The VCR will return to Tape counter mode each time it is switched on.
• If you are recording from this VCR to another, make sure you remove the display from the screen otherwise it will be
recorded.
• When power ON, channel position is displayed.
• Usually use the "channel position".
VCR Reset
1
Select VCR/DVD CHANGE Switch to VCR.
2
Press OPERATE.
3
Press and hold VCR MENU and CH " together on the Remote
Control for 10 seconds.
• VCR reset is now complete.
38
DVNC70H028_038.pm6
SUPER P. ON
SP
10:00AM
9/07 02
an operation or number button is pressed.
www.sharp.co.uk/support
38
1 CH59
NICAM
STEREO
L R
REM
1:05
0:00.00
1 CH 5 9
*1 When in tape playback
mode, "channel" is not
displayed
*1
20/8/02, 10:50 am
Advertisement
Table of Contents
