Pin assignment:
Use only the power supply unit supplied.
◆
If you buy another phone cable, ensure that it has the right connector
◆
i
assignment for your country.
Keep the power supply unit plugged in at all times to ensure your
◆
phone is ready for use whenever you need it.
Making the handset ready for service
Remove the protective film
The display is protected by a plastic film. Please remove the protective film!
Inserting the batteries
Insert the batteries the right way round – see illustration left.
◆
Place the cover on the battery compartment about 3 mm down from the latch and
◆
push it up until it clicks into position.
To open the cover, press on the depression and push cover downwards.
Insert only approved, rechargeable batteries of the same type
◆
(page 25)! Never use normal batteries, since these could lead to a
W
health hazard or cause injury.
Do not use a non-Siemens charging unit as this could damage the
◆
batteries.
Service making handset ready for service
4
3
5
2
6
1
BRD
OES
unassigned
1
unassigned
a2
2
unassigned
a
3
a
b
4
b
b2
5
unassigned
unassigned
6
unassigned
7