Appendix; Questions And Answers - Siemens Gigaset CL100 Operating Manual

Appendix

Appendix

Questions and Answers

If you have questions on the use of your telephone, you can contact us round the clock
at
www.my-siemens.com/customercare. You will also find the most frequently asked
questions and answers below.
What happens if ...
... the display is blank?
... the handset fails to respond
to a key press?
... all the icons are flashing in
the display and there is no
connection with the base
station?
... (where multiple handsets
are in use) the handset in the
base station is not charging?
... the handset does not ring?
... the caller can't hear me?
... the incoming call number is
not displayed even though CLIP
is set?
... ... entries in the caller list
don't show time or date?
... I can't hear the ringer or
dialling tone?
... I can hear an error tone
(descending tone sequence)
when keying in?
22
Possible cause
The handset is not switched
on.
The batteries are flat.
The keypad lock is activated.
The handset is outside the
range of the base.
The handset is not registered.
The base is not switched on.
The cable has not been placed
correctly in the bottom of the
base station.
Charging in the base station
only takes place when a phone
call is not being made at the
same time.
The ringer is switched off.
The ringer volume has been
set to "0".
Call divert has been set to
AUTOMATIC.
INT
You've pressed the
a result the handset has been
"muted".
Sending the phone number
(CLI) has not been enabled.
Date and time have not been
set.
You have changed the phone
cable on your Gigaset.
The function has not worked or
the entry is incorrect.
Possible solution
Press the end call key
approx. 5 secs.
Charge or replace the batteries
(page 8).
Press the hash key
R
for approx. 2 seconds to
deactivate the lock (page 8).
Move the handset nearer to the
base.
Register the handset
(page 17).
Check the power connector at
the base (page 6).
Check cable placement
(page 6)
Use additional charger unit.
Activate the ringer (page 20).
Increase ringer volume
(page 20).
Deactivate call divert
(page 12).
key. As Activate the microphone again
with MENU, BACK, OK
(page 11).
The caller should request the
network operator to enable the
transfer of his or her phone
number.
Set date and time (page 10)
When purchasing a new cord
ensure that it has the correct
pin connections (page 26).
Repeat the process; watch the
display when doing so and if
necessary check the operating
manual.
a
for