Getting To Know Your Appliance; The Control Panel; The Hotplates; Residual Heat Indicator - Siemens EF6 Series Instruction Manual

Hide thumbs Also See for EF6 Series:
Table of Contents

Advertisement

Getting to know your appliance

The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2.

The control panel

&RQWUROV IRU
# FKLOGSURRI ORFN
– H[WHQGHG FRRNLQJ ]RQH
Controls
When you touch a symbol, the respective function is activated.

The hotplates

Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
Extended cooking zone
æ
When the hotplate is activated: the corresponding indicator lights up.
When the hotplate is switched on: the last selected size is automatically selected again

Residual heat indicator

The hob has a two-stage residual heat indicator for each
hotplate.
If
appears in the display the hob is still hot. It may be used,
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display

Setting the hob

This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.

Switching the hob on and off

You can switch the hob on and off with the hotplate controls.
When the hob is switched on, the heat setting display lights up.

Setting a hotplate

Adjust the heat setting of the hotplates using the hotplate
controls.
4
'LVSOD\V IRU
KHDW VHWWLQJ
³É
‡¤
© HOHFWURQLF ERLO VWDUW FRQWURO
UHVLGXDO KHDW
&RQWUROV
DQG GLVSOD\V IRU
WKH WLPHU
Notes
Activating and deactivating
Touch the
symbol
ð
Touch the
symbol
æ
changes to
cooled sufficiently.
Power cut
If there has been a power cut, the residual heat indicator
switches back on automatically. The indicator flashes for
approximately 30 minutes. The flashing stops if you briefly
switch the hotplate on again.
0 = hotplate off
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
There is an intermediate setting between each heat setting. This
is identified by a dot.
Note: Hotplate temperature is regulated by the heat switching
on and off. The heat may also switch on and off at the highest
setting.
&RQWURO IRU
Í GXDOFLUFXLW KRWSODWH
The settings will remain unchanged if you touch several
symbols at once. This allows you to wipe up spills on the
control panel.
Always keep the controls dry. Moisture reduces their
effectiveness.
œ
. The display remains lit until the hotplate has

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ef7 seriesEf6..tn series

Table of Contents