Siemens Gigaset S79H User Manual page 40

Activating the Room Monitor and
entering the destination number
É
¢ ¢
v
Room Monitor
¤
You can enter data in the following fields:
Activation:
Select On to activate.
Alarm to:
Select Internal or External.
External number: Select the number
from the Directory (press display key
or enter it manually.
Internal number: Select display key
¢
§Change§
. Select handset or Call All to
call all registered handsets
In idle status, the destination number or
the internal destination number is dis-
played.
Sensitivity:
Select noise level sensitivity (Low or
High).
¤
§Save§
Press to save the settings.
When the Room Monitor function is acti-
vated, the idle display appears as shown
below:
i V
07:15
Á
INT 1 22 Oct
Room Monitor
0891234567
OFF Options
Changing the set destination
number
v
¤
Cancelling/deactivating the
ö Room Monitor
)
Press the end call key a to cancel the call
when the Room Monitor is activated.
¢
In idle status, press the display key
§OK§
.
deactivate Room Monitor mode.
Deactivating the Room Monitor
remotely
Prerequisites: The phone must support tone
dialling and the Room Monitor should be set
for an external destination number.
¤
The Room Monitor function will deactivate
after the call ends. There are no further
Room Monitor calls. The other Room Moni-
tor settings on the handset (e.g., no ring-
tone) will remain activated until you press
the display key
To reactivate the Room Monitor with the
same phone number:
¤
Using a handset as a Room Monitor
É
¢ ¢
Room Monitor
Enter and save number as described in
"Activating the Room Monitor and enter-
ing the destination number"
¢
( page 39).
Accept the call from the Room Monitor
and press keys 9 ;.
§OFF§
on the handset.
Turn on the activation again and save
¢
§Save§
with ( page 39).
§OFF§
to
39