Appendix; Care; Contact With Liquid; Questions And Answers - Siemens Gigaset SL150 colour Instructions Manual

Hide thumbs Also See for Gigaset SL150 colour:
Table of Contents

Advertisement

Appendix

Care

Wipe the base station and handset with a damp cloth (do not use solvents) or an anti-
static cloth. Never use a dry cloth. This can cause static.

Contact with liquid

If the handset should come into contact with liquid, on no account switch the device
on. Remove the battery immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the battery removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.

Questions and Answers

If you have any questions about the use of your phone, you can contact us 24/7 at
www.siemens.com/gigasetcustomercare. You will find the most frequently asked
questions and answers below.
What has happened if ... Possible cause
... the display is blank?
... the handset fails to respond
to a key press?
... "Base station x" flashes in
the display?
... Base Search flashes in the
display?
... the handset does not ring? The ringer is switched off.
... I cannot hear a ringer tone/
dial tone?
... the other party cannot hear
me?
... the incoming call number is
not displayed even though
CLIP is set?
... I hear an error tone (falling
tone sequence) when keying
an input?
!
The handset is not switched on.
The battery is flat.
The keypad lock is activated.
The handset is outside the range
of the base station.
The base station is not switched
on.
The handset is set for Best
Base. But no base station has
been activated or in range.
You have changed the telephone
cord on your Gigaset.
You have pressed the
key. This mutes the handset.
Calling line identification is not
enabled.
The action has failed or the input
is incorrect.
Possible solution
Press the "end call" key
about 2 sec.
Charge or replace the battery
(page 10).
Press the hash key
about 2 sec. to deactivate the
lock (page 11).
Move the handset nearer to the
base station.
Check the power connector at
the base station (page 8).
Move the handset nearer to the
base station.
Check the power connector at
the base station (page 8).
Activate/deactivate the ringer
(page 79).
When purchasing a new cord
ensure that it has the correct
pin connections (page 8).
u
(INT)
Switch on the microphone
again (page 20).
The caller should ask his net-
work provider to enable the
identification of his number
(CLI).
Repeat the procedure; watch
the display and if necessary
refer to the operating instruc-
tions.
Appendix
a
for
R
for
87

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gigaset sl100 colour

Table of Contents