3D Video; Initial Setup; Watching 3D Video; To Watch Regular (Non-3D) Video - Mitsubishi Electric WD-60C9 Basic Owner's Manual

3D Video
This section provides Instructions for viewing 3D video
using the TV's 3D feature. The 3D options are found in
the Adjust> 3D Mode menu.
Initial Setup
1.
Check if your HDMI 3D video source device
outputs a 10BOp 60 Hz signal. This information will
be needed when you assign an input name in the
New Device Found screen.
2.
If your 3D glasses came with an emitter box,
connect the emitter box to the 3D GLASSES
EMITIER jack on the back of the TV.
3D
_ _ _ _ _ _ _-,JGLASSES
r
EMITIER
3.
Power on the TV and the source device.
4. Connect the source device to the TV's HDMI input.
5. When the New Device Found screen displays,
name the input according to the table below.
The signal type and choice of name are important
because the TV will process the video signal
differently depending on the name you assign. If
your source device is a Blu-Ray disc or a game
console, the signal must be 10BOp at 60 Hz.
19
Watching 3D Video
1.
Press ACTIVITY.
2.
Highlight the icon for the 3D video input and press
ENTER.
3.
Press MENU and select the Adjust> 3D Mode
menu.
4. Set 3D Mode to On. The On setting will be memo-
rized for the current activity/input combination
when you exit this menu.
Use the Adjust> 3D Mode menu to enable 3D video
viewing.
5. Press BACK to close the menu.
6. If the image does not appear correct, open the
Adjust> 3D Mode menu again and set Glasses
l-R to Reverse to reflect the correct polarity.
To Watch Regular (non-3D) Video
Source A .
of 3D Type of 3D Video Signal NsSlgn
~~ a~
Computer
Any other
3D video
source
Recommended: 10BOp 60 Hz
(1920 X lOBO). The image will fill
the TV screen.
Other 60-Hz computer video
signals compatible with the TV
will display with black bars.
To see 3D video, signal must be
10BOp 60 Hz
PC
Any
other
name
The 3D Mode setting is memorized for each activity/
input combination. When you want to watch non-3D
video on the input selected above:
• Press ACTIVITY and select a different activity in
which the input is selectable.
• Open the Adjust> 3D Mode menu and set 3D
Mode to Off.
6. Press BACK to close the New Device Found
screen, or to change the name in the Input>Name
sub-menu.