Initial Settings - Sanyo LCD TV Owner's Manual

Table of Contents

Advertisement

Programme Selection (Previous or Next
Programme)
• Press "P -" button to select the previous
programme.
• Press "P +" button to select the next programme.
Programme Selection (Direct Access)
• Press numeric buttons on the remote control to select
programmes between 0 and 9. The TV will switch
to the selected programme. To select programmes
between 10 - 499 (for IDTV) or 10-199 (for analogue),
press the numeric buttons consecutively. The limit
of the delay time is 3 seconds.
• Press directly the programme number to reselect
single digit programmes.

Initial Settings

Before selecting a language in fi rst time installation,
power saving menu will be displayed. You should fi rst
defi ne power save mode options to advance.
Press OK button to activate power save mode. Press
Right button to activate Store Mode.
You can save energy by selecting power save mode
option.
If you select Store Mode, the following OSD will be
displayed after every standby on/off.
Picture and Backlight preferences will be changed
when you activate Power Save Mode.
Note: If you want to do Power Save Mode selection
again later, you should perform First Time Installation.
Please see First Time Installation.(Refer to Page19)
The message "Welcome please select your
language!" is displayed in all language options
sequentially in the OSD.
By pressing the " " or " " buttons highlight the language
you want to set and press OK button.
You can get information about the menu usage by
pressing INFO button. Press INFO button again to
exit the help menu.
After then, "First time installation" OSD will appear
on the screen. By pressing " " or " " buttons, select
the country you want to set and press OK button.
01_MB37_[GB]_(01_TV)_22890W_1900UK_IDTV_BRONZE13_10065805_50157832.indd 11
01_MB37_[GB]_(01_TV)_22890W_1900UK_IDTV_BRONZE13_10065805_50157832.indd 11
Note: Country selection will not be available for UK.
Press OK to continue.
After then, the active antenna selection OSD appears
on the screen:
By pressing " " or " " buttons, set active antenna
mode as on or off.
If an active antenna is connected to your TV, you can
select this option as On. Antenna power should be
"Off" when standard antenna is used instead of the
active antenna. See "Confi guration Menu" in the
following sections for more information.
Press OK button on the remote control to continue
and the following message will be displayed on the
screen:
• To select the "Yes" or "No" option, highlight the item
by using " " or " " buttons and press OK button.
The IDTV will automatically tune to the transmission
channels, searching for digital terrestrial TV broadcasts
and displaying the names of channels found. This
process will take a few minutes. To cancel searching,
you can press MENU button at any time during the
process. The following OSD will be displayed during
the automatic search:
After Automatic Search is completed, the following
message will be displayed, asking for sorting option.
If you select "YES", programme list will be sorted
English - 11 -
27.02.2010 13:55:56
27.02.2010 13:55:56

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents