Operating Instructions; Recording - Bunker Hill Security 67139 Set Up And Operating Instructions Manual

Operating instructiOns

recOrding

1
3
a-rec [m] 39%
1. Set up all the functions of the DVR
following "Programming the DVR".
2. Press the record button to begin
recording according to the schedule
you have set.
Each Channel set to record will dis-
play a recording symbol [ ] next to
the channel number.
audiO
The channel which is set to audio
will display one of the following audio
symbols next to the record symbol.
- Audio output is off.
- Audio output is on and audio
is attached to the indicated channel.
When the symbol is red it indicates
that audio is currently recording.
To mute the audio signal, press the
DOWN button. The audio signal
will continue to record and can be
heard in playback mode.
recOrding mOde
One of the following will display along
the bottom left of the screen:
a-rec - Normal recording.
SKU 67139
2
4
2009/02/22 16:09:44
For technical questions, please call 1-800-444-3353.
s-rec - Motion sensor recording.
n-rec - No recording.
Other data
The following will display along the
remaining lower edge of the screen:
[m] or [s]- Indicates which hard drive
is in use (M=Master, S= slave).
#% - Displays the percentage of hard
drive disk space used.
YYYY/mm/dd - Displays current
Year/Month/Day.
hh:mm:ss - Displays current time
(hours:minutes:seconds).
Note: If the date, time or any other
settings are incorrect you will need to
stop recording and go back to the set
up menu to reset the functions.
stOpping
To stop recording, press the
STOP button. If the password func-
tion is enabled you will be prompted
for the password and will not be able
to stop recording without the current
password.
rev 10h
Page 13