Important Safety Instructions - Thermador Ventilation Installation Manual

IMPORTANT SAFETY INSTRUCTIONS

This appliance conforms to the relevant safety
regulations.
Repairs should only be carried out by qualified
specialists.
Improperly executed repairs can give rise to significant
hazards for the user.
Your new appliance was protected on its way to
you by the packaging. None of the materials
cause pollution to the environment and all can be
recycled for use again. Please help to protect the
environment and dispose of the packaging in an
environment-friendly manner.
You can obtain information about the best
method of disposing old appliances and packa-
ging from your dealer or local municipal council.
Check if this blower is recommended by the
manufacturer to be installed with the hood.
SAFETY WARNING: Before servicing or cleaning
unit, switch power off from control panel and
unplug the appliance to prevent power from being
switched on accidentally.
If unable to switch off power, attach a tag to the
service panel to indicate power has been swit-
ched off for maintenance.
WARNING – TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO PER-
SONS, OBSERVE THE FOLLOWING:
Equipment Needed
K Drill and Bit
K Screwdriver
K Rubber Mallet
READ AND SAVE THESE INSTRUCTIONS.
PAGE 1
A. Installation work and electrical wiring must be
handled by qualified person(s) in accordance with
all applicable codes and standards, including fire
and construction codes.
B. Sufficient air is needed for proper combustion
and exhaust of gases through the flue
(chimney) of cooking surface to prevent back
drafting. Follow the heating equipment manufac-
turers guideline and safety standards such as
those published by the National Fire Protection
Association (NFPA), the American Society for
Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local authority
codes.
C. When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
D. To properly exhaust air, be sure to duct air out
side. Do not vent exhaust air into spaces within
walls, ceilings, attics, crawl spaces, or garages.
WARNING: To reduce the risk of fire, use only
metal ductwork.
CAUTION – For General Ventilating Use Only.
Do Not Use To Exhaust Hazardous Or Explosive
Materials And Vapours.
This unit must be grounded.
WARNING: To reduce the risk of fire or electric
shock, do not use this fan with any solid-state
speed control device.
Equipment Included
K Anchors (4)
K Screws (4)
K Installation Instructions
K Connector