Power Trim And Tilt Switches (Twin Binnacle Type); Trim Tab With Anode - Yamaha F115D Owner's Manual

while the boat is moving could increase
the risk of falling overboard and could
distract the operator, increasing the risk
of collision with another boat or an obsta-
cle.
UP
DN
NOTE:
For instructions on using the power trim and
tilt switch, see page 37.
EMU26161
Power trim and tilt switches (twin
binnacle type)
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pushing the switch "
outboard motor up, then tilts it up. Pressing
the switch " " (down) tilts the outboard mo-
tor down and trims it down. When the switch
is released, the outboard motor will stop in its
current position.
1
DN
UP
1. Power trim and tilt switch
NOTE:
G
G
EMU26240

Trim tab with anode

The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
EWM00840
ZMU04223
An improperly adjusted trim tab could
cause difficult steering. Always test run
after the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
If the boat tends to veer the left (port side),
turn the trim tab rear end to the port side "A"
in the figure. If the boat tends to veer the right
(starboard side), turn the trim tab end to the
" (up) trims the
starboard side "B" in the figure.
ECM00840
The trim tab also serves as an anode to
protect the engine from electrochemical
corrosion. Never paint the trim tab as it
will become ineffective as an anode.
ZMU04601
Basic components
On the dual engine control, the switch on
the remote control grip controls both out-
board motors at the same time.
For instructions on using the power trim
and tilt switches, see pages 35 and 37.
WARNING
CAUTION:
16