Personal Safety - Chicago Electric 92158 Assembly And Operation Instructions Manual

grounded tools must be plugged into an outlet properly installed and grounded
6.
in accordance with all codes and ordinances. never remove the grounding
prong or modify the plug in any way. do not use any adapter plugs. check with
a qualified electrician if you are in doubt as to whether the outlet is properly
grounded. If the tools should electrically malfunction or break down, grounding
provides a low resistance path to carry electricity away from the user.
7. double insulated tools are equipped with a polarized plug (one blade is wider
than the other). this plug will fit in a polarized outlet only one way. if the plug
does not fit fully in the outlet, reverse the plug. if it still does not fit, contact a
qualified electrician to install a polarized outlet. do not change the plug in any
way. Double insulation
cord and grounded power supply system.
do not abuse the power cord. never use the power cord to carry the tools or
8.
pull the plug from an outlet. Keep the power cord away from heat, oil, sharp
edges, or moving parts. replace damaged power cords immediately. Damaged
Power Cords increase the risk of electric shock.
when operating a power tool outside, use an outdoor extension cord marked
9.
"w-A" or "w". These extension cords are rated for outdoor use, and reduce the risk
of electric shock.
10. stay alert. watch what you are doing, and use common sense when operating a
power tool. do not use a power tool while tired or under the influence of drugs,
alcohol, or medication. A moment of inattention while operating power tools may
result in serious personal injury.
11. dress properly. do not wear loose clothing or jewelry. contain long hair. Keep
your hair, clothing, and gloves away from moving parts. Loose clothes, jewelry, or
long hair can be caught in moving parts.
12. Avoid accidental starting. be sure the power switch is off before plugging in.
Carrying power tools with your finger on the Power Switch, or plugging in power tools
with the Power Switch on, invites accidents.
13. remove adjusting keys or wrenches before turning the power tool on. A wrench
or a key that is left attached to a rotating part of the power tool may result in personal
injury.
14. do not overreach. Keep proper footing and balance at all times. Proper footing
and balance enables better control of the power tool in unexpected situations.
15. use safety equipment. Always wear eye protection. Dust mask, non-skid safety
shoes, hard hat, or hearing protection must be used for appropriate conditions.
for technical questions, please call 1-800-444-3353.
SKU 92158
eliminates the need for the three wire grounded power

personal safety

Page 3