Central Machinery 38123 Assembly And Operating Instructions Manual page 8

3. The smaller the gauge number of the wire, the greater the capacity of the cord. For
example, a 14 gauge cord can carry a higher current than a 16 gauge cord.
(See Figure C.)
4. If using more than one extension cord to make up the total length, make sure each cord
contains at least the minimum wire size required. (See Figure C.)
5. If you are using one extension cord for more than one tool, add the nameplate amperes
and use the sum to determine the required minimum cord size. (See Figure C.)
6. If you are using an extension cord outdoors, make sure it is marked with the suffix
"W-A" ("W" in Canada) to indicate it is acceptable for outdoor use.
7. Make sure your extension cord is properly wired and in good electrical condition. Always
replace a damaged extension cord or have it repaired by a qualified electrician before
using it.
8. Protect your extension cords from sharp objects, excessive heat, and damp or wet
areas.
RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS*
NAMEPLATE
AMPERES
(At Full Load)
0 – 2.0
2.1 – 3.4
3.5 – 5.0
5.1 – 7.0
7.1 – 12.0
12.1 – 16.0
16.1 – 20.0
SKU 38123 For technical questions, please call 1-800-444-3353.
(120 VOLT)
EXTENSION CORD LENGTH
25 50
Feet Feet
18 18
18 18
18 18
18 16
18 14
14 12
12 10
* Based on limiting the line voltage drop
to five volts at 150% of the rated amperes.
SYMBOLOGY
Double Insulated
Canadian Standards
Association
Underwriters Laboratories,
Inc.
V ~
Volts Alternating Current
A
Amperes
No Load Revolutions per
no
xxxx/min.
Minute (RPM)
75 100
Feet Feet
18 18
18 16
16 14
14 12
12 10
10 -
- -
FIGURE D
150
Feet
16
14
12
12
-
-
-
FIGURE C
Page 8