Operating Instructions - Central Machinery 38123 Assembly And Operating Instructions Manual

BASE (42)
WASHER (8)
KNOB (1)
To Install The Backstop:
Place the Backstop (9) over the Bed (4), and use a Hex Screw (6), Lock Washer (7),
and Flat Washer (8) to secure the Backstop to the Bed. The Backstop must not be in
contact with the Sanding Belt (10). (See Figure H.)
BED (4)
To Adjust The Worktable For Vertical Sanding:
1. Remove the Hex Screw (6), Lock Washer (7), and Flat Washer (8). Then, remove the
Backstop (9). (See Figure H.)
2. Unscrew and remove the Knob (1). (See Figure I, next page.)
3. Pull the Index Pins out of the mounting holes in the Table Support (36).
(See Figure G.)
SKU 38123 For technical questions, please call 1-800-444-3353.
INDEX PIN
TABLE SUPPORT (36)

OPERATING INSTRUCTIONS

1/16" MAX. BETWEEN
SANDING SURFACE
WORKTABLE EDGE
TABLE
ANGLE SCALE
FIGURE G
HEX SCREW (6)
LOCK WASHER (7)
FLAT WASHER (8)
BACKSTOP (9)
WRENCH
(NOT INCLUDED)
FIGURE H
Page 11