Advertisement
protective sheet from the pad, do not
touch the adhesive side.
Press the suction cup of the mounting
device against the pad (2B). Turn the
catch on the mounting device to the
desired position (2C). Rotate the ring
on the mounting device clockwise
(2D) to create a vacuum between the
suction cup and the pad.
To detach the suction cup from the
pad, proceed in the same way as when
you detach the cup from a windscreen
(9, 10, and 11).
Place or remove the mobile device
Do not place or remove a mobile
device while driving.
To place your device into the holder,
lift the latch (see step 3), and turn it to
the back (4). Slide the mobile device
into the holder (5). Turn the latch over
the device (6), and slide the switch at
Attach the holder to the
mounting device
To attach the mobile holder to the
mounting device, insert the catch on
the mounting device into the slot at
the back of the holder (see step 2E).
Rotate the holder clockwise about 90
degrees until it locks into place (2F).
Check that the mounting device is
firmly attached (2G).
To detach the holder from the
mounting device, rotate it
anticlockwise.
the top of the holder to the right to
lock the device firmly in place (7).
To charge the battery of your device,
use a compatible charger. To attach
the charger cable to the back of the
holder, insert the cable into the cable
support (8), and connect the charger
ENGLISH
Advertisement
