Chicago Electric 38391 Set Up And Operating Instructions Manual page 6

If you use the Jump-Start with a
power inverter (not included) as a
120 V~ power source, Table 3 will
give you approximate times to expect
with a fully charged unit.
table 3
120 V~ Power Source Usage Times
using a power inverter (not included)
appliance
Spotlight, DVD
Player, Sump Pump
Faxes/TV's
Small Appliances
Computers/Printers
Medium Power Tool,
Blender
note: The appliance will be plugged into
the power inverter (not included), and
the 12 VDC Cigarette Lighter plug
from the inverter will plug into the 12
VDC Cigarette Lighter Receptacle on
the side of the unit.
SKU 38391 For technical questions, please call 1-800-444-3353.
estimated estimated
power use
(watts) (hours)
100 1.5
150 1
200 0.75
250 0.5
Jump starting a vehicle
note: Press the Light Switch to
1.
activate Work Light in case it is
needed.
2. Attach the red (+) Clamp (1) to the
red (+) positive battery terminal.
3. Attach the black (-) Clamp (2) to a
non-moving metal engine part on
negative ground systems, not to
the negative (-) battery terminal.
4. Turn the On/Off switch to "On".
5. Turn the ignition to "On"- Accessory
(not start) and wait a couple of
minutes.
6. Attempt to start the engine for no
more than 5-6 seconds.
7. If the vehicle does not start, wait at
least three minutes until trying again.
Repeated attempts may flood the
engine or wear out the engine starter.
If unable to start, replace the battery.
warning! do not let the black and
red clamps touch each other or a
common metal conductor.
8. When the engine is running, switch
off the Jump-Start.
Disconnect the black (-) Clamp and
9.
return it to its position on the Jump-
Start. Then, disconnect the red (+)
Clamp and return it to its position on
the Jump-Start.
10. After each jump start, fully recharge
the Jump-Start battery until the DC
Charging LED turns off.
Page 6