Mitsubishi Electric Mr. Slim MSZ-GE06NA Service Manual page 29

OPERATING PROCEDURE
2. Removing the indoor electronic control P.C.
board and the room temperature thermistor
(1) Remove the panel (Refer to 1.) and the corner box.
(2) Remove the screw of the V.A. clamp and the V.A.
clamp.
(3) Remove the screw of the electrical cover and the
electrical cover.
(4) Remove the screw of conduit cover and the conduit
cover.
(5) Remove the screw of conduit plate, the conduit plate
and the indoor/outdoor connecting wire.
(6) Open the indoor electronic control P.C. board holder (to
right side)
(7) Disconnect the following connectors:
<Indoor electronic control P.C. board>
CN112 (Indoor coil thermistor)
CN151 (Vane motor)
CN10A (To the indoor power P.C. board)
(8) Unhook the catches of the indoor electronic control P.C.
board holder from the nozzle and the electrical box
(right side).
(9) Remove the room temperature thermistor from the
hook of the indoor electronic control P.C. board hold-
er.
(10) Open the back side of the indoor electronic control P.C.
board holder, and remove the indoor electronic con-
trol P.C. board.
(11) Remove the room temperature thermistor from the
indoor electronic control P.C. board.
3. Remove the indoor power P.C. board, the indoor
terminal P.C. board, and the electrical box
(1) Remove the panel (Refer to 1.) and the corner box.
(2) Remove the indoor/outdoor connecting wire (Refer to
2 (2)-(5).).
(3) Remove the ground wire connected to the indoor heat
exchanger from the electrical box.
(4) Unhook first the lower, then the upper catches of the
electrical box, and pull out the electrical box.
(5) Disconnect all the connectors on the indoor power P.C.
board and unhook all lead wires.
(6) Remove the screw of terminal block on the indoor ter-
minal P.C. board.
(7) Remove the indoor power P.C. board and the indoor
terminal P.C. board.
Photo 2 Ground wire
Catch of indoor electronic
control P.C. board holder
Photo 3
Indoor terminal
P.C. board
Terminal block
Catch of indoor
electronic control
Screw of the
P.C. board holder
conduit cover
29
PHOTOS
Electrical box
Screw of the
electrical cover
Screw of the
V.A. clamp
Indoor electronic
control
P.C. board holder
Upper catch
Indoor power
P.C. board
Lower catch
Screw of the
conduit plate