Radio Reception - TECHWOOD DDR 95 Owner's Manual

AUDIO OPERATIONS

Radio Reception

Auto Tuning
POWER ON
1. Select the TUNER mode by turning the FUNCTION
selector.
2. Select AM or FM by pressing the BAND selector
button.
3. Press the MODE button to change to TUNING mode.
(The PRESET CH. indicator disappears from the display).
This button is used to select Tuning or Preset scan
mode.
4. Press and hold the UP or DOWN TUNING button
(between 0.5 to 2 seconds).
The next station broadcasting at a frequency
higher or lower than that of the current
station is automatically detected and tuned in.
By pressing and holding the TUNING button for
longer than 2 seconds, it will continue to control
(three times faster than normal speed).
FM MODE Button
Pressing this button alternates between Stereo
mode and Mono mode.
• Stereo
FM stereo broadcasts are received in stereo and
the STEREO indicator lights in the display.
If FM broadcasts with weak signal strength are
received, the FM muting function works
automatically to cut the signals.
• Mono
To compensate for weak FM stereo reception,
select this mode. Reception will now be forced
monaural, reducing unwanted noise.
TUNED Indicator
"TUNED" appears in the display when a broadcast
is correctly tuned in.
Manual Tuning
FM MODE
POWER ON
Manual Tuning is generally used to tune to stations
broadcasting a signal that is too weak to be received by
Auto Tuning.
1. Select the TUNER mode by turning the FUNCTION
selector.
2. Select AM or FM by pressing the BAND selector
button.
3. Press the MODE button to change to TUNING mode.
(The PRESET CH. indicator disappears from the
display).
4. When the UP or DOWN TUNING button is pressed
momentarily (0.5 second or less), the frequency
changes by a fixed step (see STEPS below).
STEPS
FM : 100-kHz steps
AM : 10-kHz steps
- 14 -
FM MODE