Troubleshooting - Sanyo LED-32XR10F Instruction Manual

If, after reading these operating instructions, you have additional questions related to the use of your television, please
call the services center in your local area.
Before calling service, please check the symptoms and follow suggested solutions.
Remote Control
Problem
Remote control does not operate
Video and Audio
Problem
No picture (screen not lit),
No sound
Dark, poor or no picture
(Screen lit), good sound
No color/dark picture/abnormal color
Only snow and noise appear
on the screen
Dotted lines or stripes
Double images
Good picture, no sound
Audio noise
General
Problem
One or some channels can't be
displayed
Lost password
Some items can't be accessed
TV cabinet creaks
Remote control command is not
effect in some cases.
Control buttons do not operate
POWER button responds slowly
after power is connected.
Note: If your problem is not solved, turn your unit off and then on again.
Cautions: Never attempt to repair a defective TV yourself.

Troubleshooting

Possible Solutions
The batteries could be weak. Replace the batteries.
!
Check the orientation of the batteries.
!
Make sure the power cord is plugged in.
!
Possible Solutions
Make sure the power cord is plugged in.
!
Press POWER on the TV or on the remote control.
!
Try another channel; it could be station trouble.
!
Select a proper picture mode.
!
Adjust the brightness in the video setting.
!
Check the antenna/cable connections.
!
Adjust the color saturation in the video setting.
!
Check the antenna/cable connections.
!
Try another channel; it could be station trouble.
!
Adjust the antenna.
!
Move the TV away from noise sources such as cars, neon signs, or hair dryers.
!
Using a highly directional outdoor antenna or a cable may solve the problem.
!
The sound may be muted. Press MUTE again to cancel.
!
Communication problems may occur if infrared communication equipment
!
(e.g., infrared cordless headphones) is used near the TV. Move the infrared
communication equipment away from the TV until the noise is eliminated.
Possible Solutions
These channels may be set skipped. You may cancel the skip setting through
!
Programme Edit sub-menu or select them with 0-9 number buttons.
These channels may be locked or blocked, you may go to LOCK menu and set
!
Lock System to Off.
You may use the super password (2580).
!
If a setting option appears in gray, this indicates that the settings option is
!
unavailable in current input mode.
When the TV is in use, there is a natural rise in temperature, causing the
!
cabinet to expand or contract and may be accompanied by a slight creaking
noise. This is not a malfunction.
! During the timing of USB device detection (i.e. when the TV is turned on with
USB device connected, or when you plug in USB device during TV working),
the TV may not act by remote control buttons in such case. Wait some time,
then it is OK.
Disconnect the power cord and wait for a few seconds. Then re-plug the
!
power cord and turn on the unit again.
When you push POWER SWITCH to power on the TV, in about 3 seconds the
!
POWER button starts to respond after pressed.
35