Download  Print this page

SANYO HEC-DR8700 Instruction Manual Page 9

Massage lounger.
Hide thumbs

Advertisement

Repeat display
Flickers if you press the Repeat button on the
sensor controller to repeat the current massage
in a Whole Body Sensor Automatic
Course or Automatic Course.
Illuminates if the fingers (hand) are not placed
on the sensor during a measurement of stress
and stiffness in the Whole Body Sensor
Automatic Courses.
STRESS display
Shows the degree of stress
after stress measurement.
WHOLE BODY SENSOR
AUTOMATIC COURSE display
Turns on during a Whole Body
Sensor Automatic Course.
(
flickers)
does not light up if
the fingers (hand) are not placed
on the sensor correctly.
SOLE WARMER display
Turns on when the sole
heater is on.
STRESS/STIFFNESS
sensor mode display
The following icon appears sensor modes.
Stress measurement mode
Stiffness measurement mode
Sensor controller
RECLINING buttons
Adjusts the angle between
the back rest and foot rest.
The back rest and foot rest
are moved in conjunction
with each other.
Repeat button
If this button is pressed
during Whole Body Sensor
Automatic Courses or
Automatic Courses, the
current massage pattern
will be repeated once.
STIFFNESS display
The upper part of the lamp indicates the degree of
stiffness, and the lower side of the lamp indicates the
degree of relaxation. The more the upper part of the lamp
is illuminated, the higher the degree of detected stiffness.
Shoulder position measurement /
Original position display
The "SHOULDER" icon flickers when the user (the shoulder
position) is being measured, and "ADJUST"
lights up when the measurement is over.
Body pressure display
Shows the degree of pressure between your
body and the massaging rollers.
STRENGTH adjustment display
Shows the degree of massage strength. You can adjust the
massage strength while this indicator is lit, by using the
STRENGTH UPPER BODY and LOWER BODY buttons.
Front
Rear
Body areas that can be massaged.
Areas where a high degree of stiffness has been detected.
Areas where a low degree of stiffness has been detected.
Sensors
The degree of perspiration is measured if the
fingers are placed on the sensors during a
Whole Body Sensor Automatic Course.
To measure stress
Grip the sensor controller with
both fingers (hands) so that the
four sensors at the upper and
lower portions are touched.
(Stress will be measured based
on heart rate variability .)
To measure stiffness
Grip the sensor controller with one
fingers (hand) so that the lower three
sensors are touched.
(Stiffness will be measured based
on the amount of perspiration
from your hand.)
Sensors react to the surrounding situation.
8

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: