Sanyo HEC-DR8700 Instruction Manual page 20

MASSAGING (WHOLE BODY SENSOR AUTOMATIC COURSES) (continued)
7
Stiffness is measured.
Grip the sensor controller with your fingers (with one hand) so that three
①
sensors are touched.
Be sure to place your fingers (hand) on the sensor. The degree
●
of stiffness cannot be measured if your fingers (hand) are not
placed on the sensor. (If your fingers (hand) are not gripping
the sensor, "Grip the sensor" on the remote control will be
illuminated. (The icon
measured.)) If your fingers (hand) are not touching the sensor
points, massages will be carried out according to the standard
operation of the selected course.
Before gripping the sensor
Measure the position of shoulder.
②
Check if the position of shoulder is correct. If not, adjust the position using the ROLLER POSITION
●
buttons. (The ROLLER POSITION buttons can also be used while massaging is in progress.)
Measurement of shoulder position
Massaging rollers move up and down to measure the position of shoulder.
(Sit deeply on the massage chair and raise your head slightly. The matching of the position of
shoulders may not be possible if the head is leaning on the back rest.)
Massaging operation at recognized position of shoulder.
Check that massaging rollers match the position of your shoulder. If not, when the lamp of
is flickering (a beep sounds), adjust the position by pressing the ROLLER POSITION buttons.
The massaging rollers are moved up or down by approx. 1 cm (
the ROLLER POSITION button is pressed.
When it is difficult to adjust with ROLLER POSITION button, move your body for
adjustment. The height that can be adjusted is between approx. 150 (59
to 180 cm (71").
Decides the position of shoulder.
③ Sensor massaging will start.
Measures the degree of stiffness in each part of body with the sensor and informs of the degree of stiffness.
●
Displays the aim of massaging positions, the stiffness, body pressure and the remaining massaging time on the remote control.
The explanation uses stiffness as an example.
SENSOR MASSAGE
Measurement of the degree of stiffness.
The sensor will display the positions of stiffness
(those where stiffness has been detected) by
measuring the amount of perspiration from your
hand in reaction to sensor massage.
19
lights up when the user is being
After gripping the sensor
How to grip the sensor controller How to grip the sensor controller
when the icon when the icon
the remote control display the remote control display
Rear of sensor controller
Sensors Sensors
3
/ ") each time
8
1
")
/
4
Massaging rollers
Displays the position where the
stiffness has been detected.
Body areas that can be massaged.
Areas where a high degree of stiffness has been detected.
Areas where a low degree of stiffness has been detected.
is shown on is shown on
(Remote control display)
Position too high
Appropriate position
Position too low