Download  Print this page

SANYO HEC-DR8700 Instruction Manual Page 18

Massage lounger.
Hide thumbs

Advertisement

MASSAGING (WHOLE BODY SENSOR AUTOMATIC COURSES)
1
4
6
1
Press the OPERATION ON/OFF button.
2
Open the cover of the remote control.
3
Turn the sole warmer ON/OFF.
When the room temperature is low, such as in winter, it takes some time to warm up or you may not feel warm.
*
When the sole warmer is in LOW mode, the heating temperature is
adjusted automatically based on the room temperature.
LOW mode saves power consumption by approximately 15 % (compared
*
to HIGH mode, at room temperature of 25°C (77
4
Adjust the angle and position of the back rest and the foot rest.
(See page 12 - 15)
17
When the button is pressed, the lamps of the sole warmer and remote control
will illuminate, and the sole warmer will turn on.
When the foot rest is fully lowered, the foot rest will rise a little.
When the massaging rollers are not located in the upper section, the massaging
rollers will move to the upper section and stop. [at the origin]
(During the movement, the icon of "ORIGIN" on the remote control flickers.)
Press the SOLE WARMER button. The sole warmer mode changes as follows each
time the button is pressed. The current mode can be identified by the status of the
corresponding lamp (when the sole warmer is on, the SOLE WARMER HIGH or
LOW lamp is lit).
HIGH
(Lit)
If you feel that the sole warmer is too hot, turn it off by pressing the SOLE
WARMER button.
Room temperature is high
Room temperature is low
5
2
(See page 23)
LOW
(Lit)
(Neither lamp is lit)
Heating temperature is set to LOW.
Heating temperature is set to HIGH.
4
3
OFF
)

Advertisement

Table of Contents

   Related Manuals for SANYO HEC-DR8700

Comments to this Manuals

Symbols: 0
Latest comments: