BEFORE YOU CAL FOR SERVICE
If the oven fails to operate:
A) Check to ensure that the oven is plugged in
securely. If it is not, remove the plug from the
outlet, wait 10 seconds and plug it in again
securely.
B) Check for a blown circuit fuse or a tripped
main circuit breaker. If these seem to be
operating properly, test the outlet with another
IF NONE OF THE ABOVE RECTIFIES THE SITUATION, THEN CONTACT A QUALIFIED
TECHNICIAN. DO NOT TRY TO ADJUST OR REPAIR THE OVEN YOURSELF.
INSTALLATION
Make sure that all the packing materials are removed from the inside of the door.
1.
WARNING: Check the oven for any damage, such as misaligned or bent door, damaged door
2.
seals and sealing surface, broken or loose door hinges and latches and dents inside the cavity or
on the door. If there is any damage, do not operate the oven and contact a qualified service
personnel.
This microwave oven must be placed on a flat, stable surface to hold its weight and the heaviest
3.
food likely to be cooked in the oven.
Do not place the oven where heat, moisture, or high humidity are generated, or near combustible
4.
materials.
For correct operation, the oven must have sufficient airflow. Allow 20cm of space above the oven,
5.
10cm at back and 5cm at both sides. Do not cover or block any openings on the appliance. Do not
remove feet.
Do not operate the oven without glass tray, roller support, and shaft in their proper positions.
6.
Make sure that the power supply cord is undamaged and does not run under the oven or over any
7.
hot or sharp surface.
The socket must be readily accessible so that it can be easily unplugged in an emergency.
8.
Do not use the oven outdoors.
9.
Please be advised that these Sanyo Microwave Ovens are not to be installed or used within an
10.
enclosed cabinet.
appliance.
C) Check to ensure that the control panel is
programmed correctly and the timer is set.
D) Check to ensure that the door is securely
closed engaging the door safety lock system.
Otherwise, the microwave energy will not flow
into the oven.
2
Need help?
Do you have a question about the EM-S357BW and is the answer not in the manual?