Setting the Remote Control to Operate Your TV
The explanations below show you what functions individual
buttons have when the VCR/TV switch
To switch the TV on from standby mode (OFF) or vice
On some TVs it is only possible to switch the TV to standby
mode (OFF) with this button, but not on. In this case, try to
turn the TV on with one of the following buttons:
To select the programme positions (1–99) on the TV.
To select the desired AV input on the TV.
To adjust the volume of the TV.
To select the desired programme position (TV station) on
You can operate the TVs of the manufacturers listed below
with the remote control after setting it.
is set to "TV".
This setting procedure allows you to operate the TVs of some
manufacturers using the supplied remote control.
≥ Set the VCR/TV switch
≥ If you are using a Panasonic TV, this setting has already
been made, and so you do not need to perform the above
setting procedure. However, this remote control may not
work with some Panasonic TVs.
≥ Some TV models cannot be operated using this remote
control (including all TVs non-remote compatible).
12 PHILIPS, SAMSUNG
Find the manufacturer number of your TV while
referring to the following table.
While holding down the POWER button
to enter the manufacturer
number. This completes the settings for the TV
≥ Be sure to enter the number in two digits.
Example: 1 ) 01
To confirm the correct settings were made, check
whether the TV can be operated properly.
≥ When a manufacturer has multiple numbers in the
following table, try entering other numbers if the TV
operations cannot be performed properly, and then
select the optimal number.
, use the