Connections - Panasonic NV-SJ407EE Operating Instructions Manual

Connections

This section shows you how to connect the VCR to an aerial, TV, etc.
When the VCR is turned on after
unpacking and connecting the aerial
cable and the mains lead, Plug in Auto
Tuning starts automatically.
Basic Connections
The following connections are required to
record and play back the video cassette
through the TV.
3
To mains supply
Important Information
In order to prevent electromagnetic interference from the
power supply, install the accessory clamp filter on the AC
Mains Lead as shown in the figure on the right.
≥ After passing the AC Mains Lead through the clamp filter
and looping it around once, close the clamp filter until it
clicks into place.
Connection to a TV using the 21-Pin Scart Socket
Set the RF output channel of the VCR to
"ss" (RF OFF) when the VCR is
connected to the TV via the 21-Pin Scart
cable. (See page 9.)
4
To mains supply
8
TV Set (Not supplied)
2
Aerial Connector
AV1 (TV)
Aerial Connector
2
3
(Not supplied)
AV1 (TV)
21-Pin Scart socket
Aerial (Not supplied)
IN
RF
OUT
30–50 mm
1
Aerial (Not supplied)
TV Set (Not supplied)
21-Pin Scart
socket
IN
RF
OUT
1
Aerial Input socket
Aerial Output socket
3
2
1
Aerial Input socket
Aerial Output socket