Editing; Assembly Editing - Panasonic NV-SJ200 Series Operating Instructions Manual

Editing

Assembly Editing

This function can be used to make up an edited tape from
other recordings or video sources.
A new scene can be added to the end of previous one.
Recording VCR
Other VCR or
Video movie camera
Preparations
¡ Connect a video movie camera or another VCR to this VCR
as shown.
≥ Display the VCR picture on the TV.
¡ Insert the cassette on which the copying is to be performed,
and make sure that its erasure prevention tab is not broken
out.
≥ Make sure that the system is set properly. See page 17.
¡ Select the audio source required by pressing the INPUT
SELECT button to set AV.
26
AUDIO IN / VIDEO IN
IN
IN (AV1) OUT
RF
VIDEO
OUT
AUDIO
Operations
1 Press the Play button
2 At the point where you want to join a new scene, press
the Pause/Slow button
mode.
3 Press the REC button
mode.
4 Start playback on the source unit and search for the
point from which you want to record (copy) onto this
VCR.
5 When that point is reached, press the Pause/Slow button
again to start recording the new picture and sound
from the playback unit.
6 To record (copy) additional scenes, press the Pause/
Slow button to put this VCR in the recording pause
mode and then perform above steps 4 and 5 again.
7 At the point where you want to stop recording, press the
Stop button to finish recording.
Notes:
≥ If you leave the VCR in the recording pause mode for more
than 5 minutes in step 3 or 6, the VCR automatically
switches over to the stop mode to protect the video heads.
¡ If "DIRECT REC" is set to "ON", set to "OFF" and
disconnect Audio/Video cable from TV.
to start playback.
to put it in the still playback
to put it in the recording pause