Contact With Liquid; Questions And Answers - Gigaset AS150 Manual

Care
Wipe the base station, charging cradle and handset
with a damp cloth (do not use solvent) or an anti-
static cloth.
Never use a dry cloth. This can cause static.

Contact with liquid

If the handset has come into contact with liquid:
1 Switch off the handset and remove the bat-
tery pack immediately.
2 Allow the liquid to drain from the handset.
3 Pat all parts dry, then place the handset with
the battery compartment open and the keypad
facing down in a dry, warm place for at least
72 hours (not in a microwave, oven etc.).
4 Do not switch on the handset again until it is
completely dry.
When it has fully dried out, you will normally be
able to use it again.

Questions and answers

If you have any queries about the use of your tele-
phone, go to
www.siemens.com/gigasetcustomercare
for assistance 24/7. The table below contains a list
of common problems and possible solutions.
Problem Cause
Nothing The handset is not
appears in the switched on.
display.
Battery pack is
flat.
No response The keypad lock is
to key press, activated.
"HOLD KEY"
appears in the
display.
No wireless The handset is
connection to outside the range
the base, dif- of the base.
ferent icons The handset is not
flash in the registered.
display. The base is not
switched on.
Cords not routed
correctly
You cannot The supplied
hear a ring/ phone cord was
dialling tone not used or it has
from the fixed been replaced by
network. a new cord with
the wrong pin
assignment.
!
Solution
Press the end call
a
key for approx.
5 seconds or place
the handset in the
base.
Charge/replace the
battery pack (page 2).
R
Press the hash key
for approx. 2 sec
(page 3).
Move the handset
closer to the base.
Register the handset
(page 4).
Check the power con-
nector at the base
(page 2).
Check cord routing
(page 2).
Please always use the
supplied phone cord
and ensure that the
pin connections are
correct when purchas-
ing a new one
(page 2).
7
Problem Cause
Error tone The system PIN
after entering entered is incor-
system PIN. rect.
Forgot PIN
Authorisation
This device is intended for analogue phone
lines in your network.
Country-specific requirements have been
taken into consideration.
We, Siemens Home and Office
Communication Devices GmbH & Co. KG,
declare that this device meets the essential
requirements and other relevant regulations
laid down in Directive 1999/5/EC.
A copy of the 1999/5/EC Declaration of
Conformity is available at this Internet
address:
http://www.siemens.com/gigasetdocs.
Solution
Restore the system
PIN to the factory set-
ting (0000). To do this
disconnect the mains
¢
unit hold down the
¢
paging-key recon-
¢
nect the mains unit
hold the paging key
down for at least a
further 2 seconds
then release it.
The resetting proce-
dure is carried out.
The handsets are
deregistered. The
calls list is deleted.