Table of Contents
Advertisement
Customer service & product warranty – Australia and New Zealand
Please have your proof of purchase ready when calling.
IMPORTANT NOTICE
Under power failure conditions, this telephone may not operate.
Please ensure that a separate telephone, not dependent upon local power,
is available for emergency use.
Questions and answers
If you have any questions about
using your phone, visit us anytime at
www.gigaset.com/service.
In addition, the following table pro-
vides troubleshooting assistance.
The display is blank.
1.
The handset is not activated.
¤ Press and hold the end call key
a.
2.
The battery is empty.
¤ Charge the battery or replace it
(¢ page 12).
"Base" flashes in the display.
The handset is outside the range
1.
of the base.
¤ Reduce the distance between
the handset and the base.
2.
The range of the base is reduced
because Eco Mode mode is acti-
vated.
¤ Deactivate Eco Mode or reduce
the distance between the
handset and the base.
3.
The base is not activated.
¤ Check the base power adapter.
44
"Put into base" or "Register HS"
flashes in the display.
The handset has not been regis-
tered with the base or has been de-
registered.
¤ Place the handset in the base
(automatic registration, may take
up to 5 minutes) or register the
handset manually (¢ page 14).
The handset does not ring.
The ringer is switched off.
¤ Activate the ringer (¢ page 40).
You cannot hear a ringtone/dial-
ling tone from the fixed line.
The phone cord supplied has not
been used or has been replaced by a
new cord with the wrong pin con-
nections.
¤ Please always use the phone cord
supplied or ensure that the pin
connections are correct when
purchasing from a retailer.
The connection always terminates
after approx. 30 seconds.
Repeater activated/deactivated.
¤ Activate/deactivate the handset
(¢ page 21).
Advertisement
Table of Contents
