Using Several Handsets; Internal Calls - Gigaset A120 Manual

Manual registering: Other handsets
Other handsets are registered as follows:
1. On the handset: Start to register your handset
as described in its operating instructions.
2. On the base: Press the register/paging key on
the front of the base (page 1) for approx. 3 sec.
The registration process starts.
De-registering handsets
You can de-register another handset from any reg-
istered Gigaset A12 handset as follows:
¢
Select handset
INT
¢
DE-REG H/SET OK
Enter the system PIN (default is 0000)
¢
DE-REGISTER? OK
The internal number disappears from the de-regis-
tered handset. Handsets that have not been de-
registered retain their internal number.

Using several handsets

Internal calls

Internal calls are no-cost calls to other handsets
that are registered to the same base.
Press the display key.
INT
Your own handset is marked "<".
either ...
Call a single handset:
Enter number of handset,
~
e.g.
or ...
Calling all handsets:
Press the star key.
P
... then
Ending the call:
Press the end call key.
a
Internal conference/Call connecting
You are in conversation with an external caller.
To confer:
(the external party hears the wait melody)
¢
INT
c
Select a handset
party).
¢
End:
MENU GO BACK
You are reconnected with the external caller.
Or to connect the call:
¢
Select a handset
¢
INT
a
call if required)
You can also press the end call key
ately (without announcing the call). If the internal
¢ ¢
MENU
¢
¢
OK
¢
a
.
2
.
(confer with internal
¢
OK.
¢
c
(announce the
Press the end call key.
a
immedi-
5
party does not answer or is busy the call will come
back to you automatically.
Barging in on an external call
You are conducting an external call. An internal
party can 'barge in' on your call and join in the con-
versation (all parties hear a beep). Requirement:
The
BARGE IN
Activating/deactivating internal barge-in
¢
MENU BASE SET
‰
(
BARGE IN
Internal barge-in
¢
The display shows
in on the call.
c
Press the talk key.
You are connected. All parties hear a signal tone.
The display shows
a
End: Press the end call key.
If one of the internal parties presses the end call
a
key , a signal tone sounds. This does not affect
the connection between the other handset and the
external caller.
Looking for a handset ("paging")
If you have mislaid your handset you can page it
with the help of the base. To do this, briefly (2 sec-
onds max.) press the register/paging key on the
front of the base (page 1). All handsets will ring at
the same time.
End paging: Briefly press the registration/paging
key (on the base) or the talk key
set.
Pressing the registration/paging key for
i
more than 2 seconds puts the base into
registration mode. The handsets will not
ring in this case.
¢
function is activated.
¢
ADD FEATURES
= on).
. You wish to barge
LINE IN USE
.
CONFERENCE
c
on any hand-
¢