Gigaset A16, CS, A31008-G4010-C102-1-7619 W10-CSTOC 17.12.03
Other settings
Setting Remote Access Code
The code is used to control the answering machine remotely via other
phones.
Press the Remote Code key for 3 seconds; you will see "Set Remote
Code".
Press digit keys to enter a code of 3 digits.
Press the Set up key to confirm.
Note: If you want to cancel the setting, simply press the Exit key to
exit.
Pulse/Tone Dialing
At the rare of the base is the Pulse/Tone switch, so you can select
either Tone or Pulse dialing mode.
Ringer On/Off
Set ringer Off: In Standby, long press the Ringer Off/Tone key on the
handset or the base until you see "Ringer Off, no interruption" on the
display and hear a confirmation beep.
Or
Set ringer On: In Standby, long press the Ringer Off/Tone key on the
handset or the base until you see "Ringer On" on the display and hear
a confirmation beep.
Mechanical Lock
At the back of the base is a mechanical lock. If you lock it, you can
prevent making calls beginning with "0".
Note: This mechanical lock can only prevent numbers beginning with
"0" from dialing out.
Low Battery Indicator (Handset)
When the handset batteries are low and need charging, its internal
program will reduce functions to save power. "Low Battery" will
appear on the display if you are not using the handset. But if you are
using the handset, you will not only see the message on the display,
but also hear beeps. When this happens, you should end the call as
soon as possible and put it back to its base to charge.
13