Table of Contents
Advertisement
A d j u s t m e n t ( Ad J)
The adjustment menu provides manual control for making mechanical adjustments. These should only be performed by a
qualified technician. The menu provides functions to reset the fixture (
trol all effects in the head (HEAd), and move the head to the home and extreme positions (
contains functions to:
•
move
ALL
effects to the
•
move each effect individually to the open, sensor, and adjustment positions. The shutter has a closed position instead of
a sensor position.
Test sequences
T e s t s e q u e n c e ( T SEQ )
Run a general test of all effects.
P r i n t e d c i r c u i t b o a r d t e s t ( SPEC / P CBT)
3 tests of the circuit board for service use.
F a c t o r y t e s t ( S PEC / F TST)
An effects test (
WT ST
test includes programs for testing sensors on the effect wheels.
Utilities
C a l i b r a t i o n ( C A L )
The calibration menu allows you to adjust the effects to achieve total uniformity between fixtures: it is not a substitute for
mechanical adjustment. Pan (
may be selected and adjusted from 1 to 255 with the arrow keys. Press [ENTER] to save the calibration.
R e s e t d e f a u l t o f f s e t s ( SPEC /dF OF )
Reset all calibrations to their factory defaults. Select
to escape.
R e s e t d e f a u l t p e r s o n a l i t y s e t t i n g s ( SP EC/ dF SE/ FA CT)
Return all personality settings (not calibrations) to their factory defaults. Select
displayed.
C u s t o m c o n f i g u r a t i o n s ( SP EC/ dF SE/ CU S1, CU S2, CUS 3)
Save and load 3 sets of custom configurations. To save a custom configuration, adjust the settings as desired, go to
CU S2
, or
CUS3
when
LO AD
is displayed.
U p l o a d m o d e ( U PLd)
Upload mode prepares the MAC 600/E to receive control software. It is normally engaged automatically by the upload device.
In certain circumstances, however, you may have to set upload mode manually as described under "Updating software" on
page 19.
14
OPEN
,
SPOS
(sensor position), and
), a movement test (
MTST
P OF
), tilt (
T OF
and press [ENTER] when
S AVE
RS T
), turn on and off the lamp (
APOS
(adjustment position - requires special tool).
), and a sensor test (
ST ST
), dimmer (
d OF
), cyan (
C OF
d FOF
and press [ENTER] when
is displayed. To load a custom setting, select it and press [ENTER]
MAC 600/E
L ON
PAT I
). The
HEA d
) used for factory quality control. The sensor
), magenta (
M OF
), and yellow (
S URE
is displayed, or press [MENU]
F ACT
and press [ENTER] when
,
Lo FF
), con-
submenu
Y OF
)
LO AD
is
CU S1
,
Hide quick links:
Advertisement
Table of Contents
